As timgr posted, the sneaky pete by KD Tools is the one I purchased and the chinese finger tool can work great as long as you have enough rope...
The Victor seals are not a true lipped seal and are much thinner than the old Felpro lipped seal was. The Victor seals may still be available but...
So far, so good. I've put around 120miles on it and no more puddles. The sneaky pete was a little tricky and slipped off 3 times but once I...
They would, if i wanted to pull the motor and bring it to them and hope they don't mess anything else up. I've had one hell of a time with them...
I'm going to try it this weekend. I have the bearing cap off, the other 2 loosened and picked up the sneaky pete today. I hope I can get it in...
Update. Felpro part# BS3165 is now a Rope type seal. I ordered it twice last week from a local parts store and both times a rope seal arrived....
Homebrew2 is correct. If are having problems starting in cold weather, you should pull the idle jets and check for junk in there and also check...
Uh, I'm going to say, "I doubt it". We are talking about a 72hp motor with a very poor intake setup. It might help if we had the 3/4" spacer...
Excellent. Has anyone changed jets? I'm just curious. As I may have said earlier, that I haven't really tested mine more than running it in...
Header was coated with black ceramic by Clifford when purchased for an additional $90 or maybe it was $75. Hopefully it will slightly reduce the...
I do agree with with the solution of moving the studs. I may be confused though. I was under the impression that he just moved them in the...
I hope so too. I've been doing a complete rebuild of my jeep. The body has been suspended from the rafters for over a year now. I rebuilt the...
Yeah, wasn't that nice of Weber to make that "adapter" work so well. I love how they market it and if you call they don't have a clue about a...
I used a 3/4" spacer for the carb, cut the oil tube and stick by 1" and then drilled and tapped the other side of the "Y" on the carb for the fuel...
Wow. Replaced it twice and it still leaks!!! Did you use the Felpro seal kit? If mine leaks, I will definitely yank the motor and have...
aha...at last. My wife was a little upset that I had another woman with me under the jeep but a special thanks goes out to Dawn. She came...
I just sent him an email. Has anyone else ever succeded at this. Everybody says it's easy to do. I want them to come give me a hand. :-)
Just kidding Glenn. Actually, the holes were never drilled out. Anyway, I finally got the upper half out and can't figure out how you guys...
I think the dowels that hold the flywheel in position are there. Look closely at the last pic I posted. You can see the ring where it is counter...
I appreciate the foresight Jim very much. So if I can just get this seal replaced tonight or tomorrow without dropping the trans like so many...
Separate names with a comma.