Coming back from town today with my daughter I wanted to show her how easy it was to slide on the ice driving if you wern't paying attention. I...
I have a locker in my Chevy Duely also they are great if your not wanting to turn much on ice. Best thing is a single weel drive so the other can...
Well I tested the 62 CJ5 with the V-6 on the ice and snow yesterday. Pulled out of the garage with it onto my iced up driveway in 2 wheel drive...
It should be fine your frame is thinner metal. I would be concerned about pulling bolts thru or bending the frame up on a heavy pull. I would put...
I am still selling them. Been out on a lot of fires lately so I haven't been posting much. They go for $10.00 a set made out of new Yellow 1 inch...
I am building a new Fire Truck for next year with a bigger Water Tank and thinking of using it to keep the inside from rusting from the water? I...
According to the Speed/Gear Chart my engine was doing 3500 rpms at 80 mph. For a short period of time I don't think that would be hard on a good...
Windows wern't down but the doors were off on the soft top! Kind of strange looking down at the road buzzing by that close sitting in the seat!! I...
Did a one time top speed test in the 65 CJ5 yesterday. I have 5.38 gears, Warn Overdrive, 31X10.5 15" tires with the V6 Engine, weight 2750 lbs....
I weighed my 1965 CJ5 with a V6 in it, full role cage, heavy duty rear bumper and warn overdrive and it scaled 2,750 lbs excactly. Mark
Thanks I did buy the hose spent 145.00 for it but hope to have end put on some of it to use as fire hoses for my Fire Truck. Don't think I can...
Mine likes 2,800 to 3,100 RPMs just fine. Seems to purrrr nice around that range on the flat open road. I like the 5.38 gears for going slow it...
Best way to adjust it is to jack the front tires off the ground so you can do easy lock to lock turns as you adjust it. That way you can feel the...
If all goes right I have a line on 300 ft of brand new hose!! Then I can go into production again. I sell lots of stuff on EBay why not chain...
Nice set up you made. Looking at the pictures it seems if you put a ring in the middle of each pull bar you could run your chains thru them and...
Man they do look nice painted black! Think I will remove mine and paint them also just because. I need to locate some more Fire Hose today just...
Just take it to a Muffler Shop and let them do it. They have the correct tube bending equipment to do the job right. I had mine done from the...
It was out of a Chevy 4X4 with floor shift and transfer case shift also on the floor. Sure worked nice cause you can form it to conform with the...
Sometimes you can have 4 like in mine. 1 for shifting, 2nd one for the Overdrive High & Low, 3rd one for engauging the Front Axle and the 4th one...
Glad they got there and worked out OK for you. Mark
Separate names with a comma.