The Jeep Guy makes a cowling cover that seal off the cowl vent for $10 + shipping. However, making one would not be that hard.
I had a similar issue with my wipers. Here is what I did to fix it. I took the wipers off and marked 12 o'clock with a black sharpie. Then...
The rebuild is looking great bcfarms... I just finished my T14 and Dana 20 rebuild on Monday, jeep is on the road again. Now the tools and...
I purchased a $25 or $30 two prong puller from NAPA and with my grinder made the necessary modifaction to pull the rear bearing. I was able to...
I have question about the synchro assembly. *The instruction say to scribe a line in the hub and slider. *Unfortunately, I missed this small...
bcfarms, I am pulling my T14 and D20 next week to do a rebuild. This will be the first time I have rebuild a transmission and transfer case so...
Steel or aluminum not sure which but leaning towards steel. I will have to make bezel tags to label the control knobs. Only problem is the...
Thanks, timgr I will take you on that offer if I do not have dimensions by this weekend. I am thinking about making up 15 to 20. I am sure their...
Could some one give me the dimensions to heater control panel pictured above? I'm in need of one and as stated by timgr a desirable part, ie not...
Here are the lights I'm looking... ST series High Brightness Round Truck Lamps...
Thanks roadhog304 it good to hear that they fit well. I will not be putting them on like you did, I bet they look great. I like the rear panel...
Found this thread will lurking at this great site. I have a few questions for anyone who has installed the off your rockers corner panels? How...
Separate names with a comma.