Lol… yah I got a gallon, still haven’t shot it yet I had to take glove box door in and they matched it to factory inside door paint and used sun...
Good work! Soo shiny ;p
Wow thought my frame was f@##&d. I’m Interested in seeing how your new frame turns out as I’m at the same point in my Jeep build.
Excellent info! Thanks a lot for quick replies. I’ll continue on my 3/16 hot rolled c channel frame. Pics posted when done. J
Hey, I did there’s sooooo much surface flak rust it’s hard to get a true reading with the calipers... I suspect from the factory it’s an 1/8. Thanks
Hey there, I have couple questions about my stock cj 5 frame that maybe someone could answer. Is the frame made of a special hardened steel, and...
Would the brackets ID not be same size as leaf spring... 1.75”.?!
Good stuff, those look just like my 7.50 power kings. Though your new tires are Deestones, bias ply? Look good ;)
Hey there if you look at “starting on my 71 build” a fellow Canadians build, you will see my 2x4 wood ghetto whirly jig and his metal engine...
Hey there, I think in your mock up of brake pedal you have hyper extented brake pedal and that's why it's hitting the block...? The degree your...
Looks good those hat channels rock....I Like the go go gadget spray booth ;p
Lol that exactly what I did too. The later jeep yj heating system really can pump out some good heat. Thats why I went this route. Only down side...
[ATTACH] [ATTACH] [ATTACH] Yj heater fits.. Floor surgery/ firewall clearance issues too. Factory glove box will be tight.. Looks top of heater...
[ATTACH] [ATTACH] [ATTACH] floor trans cover needed some new metal:)
[ATTACH] Thanks for all the info and measurments. Drains holes look good and fabbed up 14gauge covers and wing bolts.
[ATTACH] [ATTACH] 7.50/16 power kings... look good but the bias ply a bit bumpy till tire warm up.
Thanks for the pic Dave. Pic will help me fab up those covers, have to find some rubber gasket material. I wouldnt use those odd rivets I’ll...
Thanks so much for pics fyrmn very helpful and Dane for the link. I Would never of found that. I’ll post some pics thanks again
Right on. Go figure theyd be 1 inch... the cover plate overlaps the the holes roughly 1/16 aroundIt? If you don’t mind taking a measurement, what...
You rock! Thanks man
Separate names with a comma.