An oft neglected electrical connection is the body of the distributor to the engine block. I speak from experience. This might not be your...
The inner part with the finger tip recesses has 3 small arrows. The 2 on the outer rim next to the LOCK/Free words are rotation directions to...
Marvel Mystery Oil can help with noisy lifters by helping clear the gum and gunk that is keeping the lifter from fully expanding. Couldn't hurt...
The capstan winch works differently. Instead of the cable, Halyard, line, etc being secured to a drum as it is on a Ramsey, the line is given a...
You may have a clogged main jet. Most carbs have an enrichening circuit that draw extra fuel for start when the chocke is closed. The extra vacuum...
Not just any small wenches. The special wenches used on electrics, 3/8, 5/16, 11/32. Or is that 38-24-36? Probably sockets off a 1/4 drive...
x2 on the 68 or there abouts. The xnsfer case is a single lever type not the twin stick on the 66? and before.
I was looking at the featured jeep pics and came across Eddie Turners 65 cj5. ( nice jeep ) One of the later pics shows the engine bay from the...
My Dj5 was by definition a 2 wheel drive version of the Cj5. So a Dj6 is a two wheel drive Cj6. Differences in 1967 when mine was made were a...
If the trons check out. A weak fuel pump might be the culprit. Not enough fuel to the float chamber, she runs low and dies. Fuel drains back...
I haven't gone that deep yet with my barn fresh CJ however when I do delve under the gas tank I think I will use heat applied roll roofing. It...
Another thought. By yourself the Trany and Transfer case will weigh close to 300 pounds. Darn heavy. ( well maybe 200) +-/-+ I don't know how...
A note of caution. If your clutch is is in good condition now, it won't be if you pull the transmission without supporting it and pulling it...
Quick while you are at it. Would a moddy please add the pics to the Gallery in the axle section. Its these type of "thousand word" pics that are...
From the signon I believe you are looking for picks of the V6 setup? I have a 4 banger and am not sure the setup is the same. I thought that the...
Could the blanking plate be the access for a chain drive??? Maybe the drive output for a Ramsey or Braden winch? Or a chain driven auxiliary unit?...
:oops: ZORDS Drat oops fragging thing. Do you mean to tell me that when I drilled out my old exhaust manifold bolts and tapped in a slighter...
I have a 67 cj5. The axle bearings on it are behind the shims and bearing retainer ring. I have been told that earlier D44 axle had a grease zirq...
Ebay search Dwell, Tach There are tons of units that will work. If there is a Pawn shop that has tools there is a chance that one might be...
I am guessing that this isn't the last we will hear from StraightToPlaid about his front end. Karnak says there will be a pool of 90w on the...
Separate names with a comma.