SO I put a T-90 in my jeep to replace the T-86 that was in there. The new transmission does not have the two bolt holes for the mount for the...
I just pulled out the tranny in my 66 CJ5 and the gears are toast. The tranny that I pulled out is a T-86. I have a buick 231 V6 and was wondering...
Well I do have a HEI distributor and all the wires are hooked up correctly Im thinking that it may just be junk in the float bowl. Is it easy to...
OK the Buick 231 is sputtering and stalling on a incline. What do you guys think it could be Im leaning towards the carb. But what on the carb...
Has anyone done this before the #1 plug is cross threaded and the plug does not seal. Im not sure if I can just rerun a tap and fix the threads or...
I do have constant power to the acc side the problem was that there was a wire that was conected the wrong side of the volt meter from the...
I figured it out there was a constant power wire to the accessorie side of the ignition switch :mad: but got it figured out thanks for the tips.
I got the ignition wired in and it will start the jeep but when I turn it to off it will not kill the motor. I havent put a hole in the dash yet...
You have an instant message Thanks
thats what I was leaning towards for the security any way that you could scan that wiring diagram and email it to me?
I dont have it here to look at it so Im not positive that it is that distributor probably not. I am going to go pick it up this weekend but was...
I believe it does have an electronic ignition??? Can you give me a breakdown of where the wires from the distributor hook up too?
Im pretty sure its an evenfire it came from a 84 Regal. I picked up the jeep for $500 the motor was just rebuilt and put in but not wired a friend...
Hey all, I just picked up a unfinished project. Its a 66 CJ5. The previous owner started to put in a Buick V6 (carborated) the motor is all in...
Separate names with a comma.