Here's a picture of the spacers that came with my Headman headers. Essentially a peice of 3/8 id thin wall tube with a peice of 1/4 x 3/8 bar...
Could you give some details on how you determined where to port the steering box and any special tools required for disassembly or reassembly?...
I ground the end of my 7/8 socket down until it fit in the housing far enough to work. I'd loan ot to you, but I'm trying to get mine back...
I built a crossover tube for my exhaust using a chop saw making two angled cuts at about 30~40 degress. Took a little experimenting to get it...
Mike, I've got a 4" holesaw I'd be happy to loan you.
I'm guessing you're thinking about the footman loops.
I haven't done that particular swap, but I took a 4.3 Vortech from a 2000 Blazer and put it in my '72 CJ. I would suggest you get a service...
This is pretty crude because I'm not too adept with paintbrush. The top drawing is the stock cross member and it's cross section at midpoint....
I used 3" channel for the crossmember with the flanges turned up, like Hawk said, with 3 x 3 x 3/16 angle for the ends. Drilled holes to drain...
I'm working on a 2000 4.3 Vortech in my '72. It's been a challenge electronically. That year is equipped with VATS or some variant of an...
I used 3" Black Diamond springs and 1-1/2" body lift (homemade from steel tubing) to run my 33s. Maybe I over did, but it looks right on the...
I think headphones violate some local ordinances, please check with the appropriate authorities before you try them. Sorry Tim, I hate to...
In my 300 there was a seal on the speedo shaft, had to pull the fitting the calble attaches to then remove the shaft. That seal was trashed and I...
I think there is an implied "I've" in Harlow's post, Bubba. The deeper gears make it easier to move the vehicle for all the drivetrain components...
Sounds like your towing the little black cloud that Linus used to have. :( Might fill out your profile, maybe someone nearby could give you...
Good job Paul(2) getting it going again. What happened to the problem with shifting the Tcase? And Mike: "Whats so hard about a jeep transfer...
I wouldn't use a hammer on it just yet. My 300 has been converted over to twin stick, but as I remember the 'bridge' you mention slides into a...
They both have to move to get the full capabilities of the Tcase. The passener side rod controls the front output and the driver's side controls...
Mine weighed 3400 lbs before I took it apart. It was a 232 I6, t15 and D20. That was with homade bumpers, tire carrier, 33x12.50 tires, a winch...
I put in new mounts to cure clutch linkage problems and got the parts from the following vendor who distributes Daystart products....
Separate names with a comma.