My 74 was a Renegade with the rear solid panel/tire carrier...it has both front an rear side marker lights like the one in the ad/pic above.
While this is true with the weight shifting, I wouldn't say it not as effective. I think just the opposite. Without a front locker you might not...
I would do Selectable in the front(ARB, OX, E-Locker) and a cheap lunchbox locker like aussie or lockright in the rear if cost is a factor. I run...
same here I will take 3 as well
My CJ is stock height so its not the problem, the ZJ next to it on 36's and my custom longarm kit is the one I have to worry about. I had to air...
I will take one.
I have one, have had it since around 1997 or so when we restored ours and the dash pad as too far gone. Its been great as far as holding up, the...
First thing I would do is make dang sure the motor is locked, I find it hard to believe it would in less than 1 month. Try turning on the crank...
To weld cast iron and to do it right you will need a high nickel content consumable, and will need to do alot of pre and post weld heating to...
http://www.locknstitch.com/ I have used these guys before a few years ago to fix the dreaded 53 numbered cummins diesel engine cracks more than...
ignore the air rectangle cutout on mine, I just needed something to plug the old hazard hole cause I went with a GM column.
mine comes off a switch mounted on the parking brake pedal. the original one was toast so we used a micro momentary switch from radio shack. when...
This is what mine came with there. [IMG]
My 74 has the light right above the steering column, its red with a chrome ring with BRAKE embossed on it, comes on with the parking brake on. The...
I FOUND IT, I FOUND IT......by accident. Thursday in the evening i learned the hard way that my headlight switch wouldn't stay on, so after...
BTT for some help. I haven't been able to drive this thing as much since we got it all sorted out. it still runs great at first, but after 5-10...
I have quite a few buddies that run the Aussie/Lockrite's front and rear and they seem to like them, alot of bang for the buck. A few have had to...
That is a misprint on their site. They made a long and short pinion gearset that used crush sleeves. Early 95 and down ZJ's use a low and long d30...
well technically it and the late model ZJ's share the same R&P
No they will not, TJ's have a low pinion as well, but its a short low pinion like the ones used in 96+ ZJ's. its uses a Crush sleeve setup. High...
Separate names with a comma.