Tarry 99 that is one of the things I've been thinking about that may be a contributing Factor on why the passenger side binds up so much more...
Sterclan- I believe the lines are standard set up, they run from the master cylinder to fitting on the axle, hardline along the axel to the...
Wow, I have lot of things check and suggestions to consider, appreciate all the feedback. To confirm, I'm running the stock single reservoir...
My 58' cj5 134 f head has been rebuilt for a year now and the brake are giving me heck, the jeep runs great but, it stops tot well and does not...
The electronic distributors need to see a full 12 + volts. A slightly discharged battery will give you problem.
Have you tried turning over the engine a few times by hand to see if all the Exhaust values are seating completely? Also since you have the valves...
Do you have a jeep service manual?
IMO your plugs look okay, how about pictures of the head gasket and top of the block without the head installed? I don't know how you are...
I hope this is not you problem, but I had a very familiar symptoms’ with my 58 cj 5 with the F head. I through part afther part at it and finally...
I agree, I have a carter and I have no compliants about Carter 1 bl Carbs, I rebuilt mine twice, then paid a carb guy to get it right. Do it nice...
I have 11" x 2"brakes on the front of my 58' jeep Cj, they are off a Willys pick up/ Wagon and they still have the eccertiric cam. They work well...
When I did my clutch, i remember it could only go back on one or two ways becase of the tapered bolts. pay attention to to which way the bolts got...
thanks for the quick response, I found this site that shows the brakes without the spreader bar the top spring is stretched more.... to the...
[IMG]Hello all- I took off the drums off the front axel of my CJ 5 and found upgraded 11" brakes from a willys pick up / station wagon, I think...
Hello - I have 58’ CJ5 that is living up to the jeep motto, Just Empty Every Pocket. JEEP. The CJ5 was a rescue from those horrible fires in San...
[IMG]The cap I have is vented. See picture above. That being the case, I need to run the PCV and line from side valve cover to the fitting in the...
I have a 134 F head from a 1950’s jeepster. I purchased it from a jeepster builder/ restorer in Florida, besides changing to different front plate...
[IMG]Well I figured out why I have low compession, the head gasket between No. 1 & No was burnt through .. why it did this..... I am not sure....
I have not tried this... how much oil do you use to do the wet test? A couples drops?
I am hoping for stuck valves and or a bad head gasket, that would be my best case senario. What is involved in freeing up sticking valves? Clean...
Separate names with a comma.