Thanks for the info. I'll do some measuring on that one!
Hello everyone, I have limited posts, but read a lot here. I have been reading through everything I can find on carbs for the Buick v6 motors. I...
Just went for a drive in the jeep for a test run before I hit the road for the weekend. For fun, I tightened my clutch cable, (it was really...
^^^^ That is very similar. I will have to take a look at that when I open it up again.
I have been reading a lot about synchros. But it would grind a lot more if that was the case? Anyway, I will need to get back into it when I get...
it seems that this problem is fixed. In the guide here: http://www.willystech.com/wt/T90RebuildGuide/T90rebuild.htm It mentions 2 different...
That is what I have researched. That is what I will be checking next! Thanks.
The only thing that was changed in the transmission was that I put a longer shaft in it for the Buick V6 conversion. I am back to thinking that it...
I tried putting washers behind the bolt but it didn't seem to make a difference, I could try a couple more, But they are the same bolts I pulled...
Hey all, I have another T-90 trany that I am putting with my same t-case I have had for quite some time (dana 18 ). The issue: Both fit nicely...
That is a great idea, any local parts store have that? What exactly is that called you have there?
thanks all for the help! I figured it out... finally. My ampmeter was grounding out against the dash. The wires going through it had no insulators...
Facts: '50 CJ3A, Buick 231, HEI. I have some questions, but let me begin with what happened. I was up in the woods driving around and my buddy...
I have all the parts for power steering in a crate... at some point it will go on. i have no issues at all with my ross! Getting big arms! :roll:
Here's my '53 3b with SBF 289.... this thing rides better then my dads cady! [IMG]
And i made this a public album, so everyone can see it now. It is basically the whole project.... I welded and bolted the motor mounts. This was...
Well, it has been a while, but here is my completed project. Got it done back in September. For now has Ross steering still. But using advance...
For sure, all of my dads and my jeep builds have saginaw... i am limited on time for now and am just wanting to get the motor in and going... then...
I hear ya on that... haha. Why the switch to saginaw? I know people say that the stock arm may hit the bell or trany, but does it cut down on...
how did everything turn out? I am getting ready to put a 231 in my 3a with the t-90 and i am trying to keep the stock steering for now. I was...
Separate names with a comma.