cj3b

I bought a new repo tub for my 63 cj3b and i need to cut the holes in the dash and need a starting point??? lets say the center of the speedo ,say the drivers side to the center of it and from the bottom up,can anyone help me out!!!I had no tub at all when i bought it !!!

thanks in advance

George

 

George , I measured the following off my 54-3B which has an origanal tub/dash and gauge setup. Drivers side to center of speedo 20 3/4 " . Bottom of dash to center of the speedo 4 1/4 ".

 

thanks ever so much Oz i truly appreciate that but where did you take the measurement from the left from???Outside of tub,end of dash??????
again thanks

 

Outside edge of tub at the same horizontal elevation line as the center of the needle on the speedometer. Said another way... straight across the dash from the center of the speedo to the outside edge of the drivers side of the tub.