1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

How to convert d44 10spline axles to locking hubs with lockright

Discussion in 'Early CJ5 and CJ6 Tech' started by papascooties, Aug 20, 2007.

  1. papascooties

    papascooties New Member

    Just installed a lockright in the front Now for the back:? Is there a kit for the 10spline axles to allow me to install locking hubs? I have extra dana 44's all with 10spline and also dana 25's. Could I use parts off of these?
    thanks Glenn (56cj dana 44 rear with open carrier but installing locker)
     
    papascooties, Aug 20, 2007
    #1
  2. sparky

    sparky Sandgroper Staff Member Founder

    sparky, Aug 20, 2007
    #2
  3. papascooties

    papascooties New Member

    Thanks sparky I will check it out. I am just getting my feet wet on these differentials and axle modifications. btw being a retired electrical contractor I was called sparky for many years. Thanks for the welcome. Glenn
     
    papascooties, Aug 20, 2007
    #3