swinging clutch & brake petals on cj3b

installed 225 v6 .then removed all petals, what i need to know is what petals work best? or what kind of petals did you use?

thanks in advance :v6:

 

i used pedals desing for a race care they work very slick ,jared

 

I used a nice set-up from a YJ wrangler I found in a nearby junkyard. Get the whole thing, under dash/column mounting brackets, pedals, and firewall mtd. dual res. master cylinder. I had to cut and shorten the pedal arms about 2", but this depends on the stearing column used also. The YJ's pedal assembly apears to be GM and most gm stearing will bolt-up. I found a realy cool '84 Firebird column with tilt that went in real nice.
get all the electrical connections with at least a couple inches of whip.
I also had to fab a firewall plate to accomodate the new bolts. Made a pattern out of cardboard first, then cut one out of some sheet steel.
all in all, this was not as difficult as I first feared.

Rob
-----------
'78 CJ5 Renegade 360 4bbl, ford 4 spd. on-bd air
'53 CJ3b F134
'47 CJ2a L134
'53 M38A1 F134 OD
'29 Ford model AA pick-up
'53 M105A2

 

i'm planning on these for my 3b.
http://www.wilwood.com/Products/005-PedalAssemblies/002-FSMP/fsmtmc/index.asp

going disc frt and rear and hydro clutch so their gonna work great.

 

I used the willwood brake pedals and cylinders to. Nice and compact fits very well. Plus you get independant front and rear cylinders that you can adjust the bias between. Little on the expensive side but well worth it.