1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

T14-A transmission reassembly

Discussion in 'Early CJ5 and CJ6 Tech' started by jason mays, Aug 10, 2014.

  1. Aug 10, 2014
    jason mays

    jason mays New Member

    Joined:
    Nov 2, 2013
    Messages:
    20
    Hey Guys....novice mechanic here. Just about have this T14a rebuilt. All I lack is putting the input shaft on the output shaft and postioning the main bearings in the gearbox. This is were I'm kinda stuck. Don't wanna make a move until I'm sure what I'm doing. This whole time I've been following the OEM manual and at this step it says to use a W-334 thrust yoke to protect the synchros. OK...I understand you don't wanna risk damaging those brass rings but I don't have these tools and I was just wondering about alternate means of installing these bearings. Anyone have some good ideas.

    [​IMG]

    [​IMG]
     
    jason mays, Aug 10, 2014
    #1
  2. Aug 10, 2014
    mortten

    mortten I can’t put my finger on it 2024 Sponsor 2023 Sponsor 2022 Sponsor

    Peninsula, Ohio
    Joined:
    Apr 17, 2006
    Messages:
    1,740
    IIRC I used a piece of pvc pipe.
     
    mortten, Aug 10, 2014
    #2
  3. Aug 10, 2014
    Old Doug

    Old Doug Member

    Joined:
    Aug 3, 2011
    Messages:
    67
    There have been 1000s of trans put together with out these tools because most have never saw them before. One thing you could do to make it easyer driveing on the bearings is to heat the bearing up a little to make its inside slip on easyer other wise just dont try to drive them on all at once.
     
    Old Doug, Aug 10, 2014
    #3
New Posts