Motor mounts for a pontiac 151 please...

I finally found direction for my 60, I found a motor, (151), out of a 80ish cj5 and have the adapter and such to mount up to the t90 and d18 and long story short am looking for aftermarket motor mounts for the 151. I saw the same motor with the mounts I want in a picture in a thread here, but am unable to find the thread. The mounts are the style that sit flat and the rubber cushion sits between it and the tabs welded onto the frame. The bolts run strait down and holds everything together. Was hoping someone knows what i am talking about, be even beter if the guy with jeep in the thread read this. thanks

 

sound like Novak or AA motor mounts....

 

I have been to both of there web sites and have not found anything for the 151 engine. The Jeep had a 350 sbc in it and I was lucky enough to buy a 64 cj5 in really good shape (Thanks Sparky), and I wanted to use that tube and not have to cut up it up so this 151 motor should fit the jeep much better, and it bolts right up where the 350 was. I may have to make my own if cannot locate what I want.

 

I had pictured you were talking about this type of rubber mount:

https://picasaweb.google.com/lh/photo/oW6vdJWYk9tnjAwskmmUHOJVhWJ24PEskjOyp6yvw0s?feat=directlink

 

I don't have the steel, but I do have the rubber biscuits on the shelf at work, we use them underground on smaller air-cooled Deutz Diesels, if you want a set, shoot me a PM. Might not be exact, but they're close enough, if you're fabbing the steel bits yourself.

 

I have a set of them.
http://i795.photobucket.com/albums/yy234/Sidscj/DSC01650.jpg
Shoot me a PM if you think they'll work for you.

 

Thats the right style, I need to portion that bolts to the engine. They are different then what is on a sbc, they do not sit flat. They have a couple of different angles where they bolt to the motor. I will see if I can't get a picture. thanks.

 

SInce the GM 151 "Iron Duke" was factory in the early 80's CJ'sm wont the factory mounts work??

 

Anything that looks right here??
http://www.rockauto.com/catalog/raframecatalog.php
Put '81 CJ5 in the search box, and they list 4 diff motor mounts..................

 

I think I am going to have to make or fab my own, I appreciate the leads though. Hope to get engine in this weekend without to much trouble.

 

I found the thread with the mounts I am looking for, the title is... f-head out iron duke in. the mounts are on the motor in the first picture. thanks

 

Well I went another way, I had a spare cross member for the transfer case so I bolted the transfer case to the engine and sat it in then stuck member under engine the angles were not quite right for the stock engine mounts and so I put the member in the press and bent it at its original bends until it had the correct angles, the member sits on top of the frame rails, but when flat... the member hits oil pan I will need to do some trimming and a bit more fab before welding in but it seems to be a good idea.