1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Tie rod interference

Discussion in 'Flat Fender Tech' started by Phil P, Feb 15, 2011.

Page 3 of 3
  1. ralf

    ralf New Member

    Yea, I am not old enough for old school. There is no welding skill involved, you just drop in the tapered insert and tack it around the edge. I stand corrected on "high steer" the tie rod flip is higher steering.
     
    ralf, Mar 22, 2011
    #41
  2. jayhawkclint

    jayhawkclint ΜΟΛΩΝ ΛΑΒΕ

    I used Snap-On #R121. Cost me $50 off the truck. You'll be surprised how many times it gets used once your buddies find out you have one.
     
    jayhawkclint, Mar 24, 2011
    #42
  3. Redcj3a

    Redcj3a New Member

    I used a two hole, right side knuckle with a tie rod flip on my 3A. I have clearance on both sides at full turn. I used the taper and insert process. Hope these two images are loaded properly.

    Next step for me is a manual saginaw box installation.

    John

    [​IMG]
    [​IMG]
     
    Last edited by a moderator: Mar 24, 2011
    Redcj3a, Mar 24, 2011
    #43
Page 3 of 3