1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Cranky

Discussion in 'Early CJ5 and CJ6 Tech' started by 1960willyscj5, Mar 27, 2008.

  1. 1960willyscj5

    1960willyscj5 Well-Known Member

    Does any one have any idea what the size of the crank pully nut is?
    I know that 36mm is slightly too big. (Air cooled VW rear axle nut size. I used to own a '64 bus in my youthful Navy days.) 1 7/16" or slightly smaller?:?
     
    1960willyscj5, Mar 27, 2008
    #1
  2. sammy

    sammy Coca-Cola?

    I used a... 1 and 1/4? 1 and 3/8? I do not recall, but DONT put a metric wrench on there...
     
    sammy, Mar 27, 2008
    #2
  3. w3srl

    w3srl All-around swell dude Staff Member

    A pipe wrench always fits...

























    Kidding guys! :D
     
    w3srl, Mar 27, 2008
    #3
  4. Schlotka

    Schlotka default member

    1 3/8". of course the hand crank pulley nut I've found needed a 1 7/16" because the peg stuck out the sides a little.
     
    Schlotka, Mar 27, 2008
    #4
  5. 1960willyscj5

    1960willyscj5 Well-Known Member

    It's new enough not to have the handcrank bar in it.
    Darn, that would make starting with a low battery easier!:D
     
    1960willyscj5, Mar 27, 2008
    #5