Roxor - Swing Pedal Assembly

This might be a really nice donor system for a swing swap. New they are $66 and use a decent plate on both sides of the tub to remove deflection (thought the Roxor tub is much thicker). By my eyeball-calculus, the tub angle is nearly identical, so the pedal angle should be usable as-is. Lemme know if anyone wants measurements or pics.

https://cdn.datamanager.arinet.com/image/MHA/f0de5dd8-5310-4729-aaf9-03f0d9fbb4db/Medium

 

What is the measurement from the pedal foot pads to the pivot point above?

 

This looks a great possible option. I'm looking to install a swing petal set up in my 68' this winter. I'm assuming this is for a hydraulic clutch, and can be used with disc brakes? Any pics, measurements and info (like where to purchase the parts) would be appreciated. Thanks!

 

14”

 

Correct, hydro clutch, and front disc, rear drum. Parts can be had from a dealer. The Roxor site has a dealer finder page.

Pics (including a shameless plug of the windshield and grill swap):

Imgur

 

So I found the parts in the catalogue. For the petal assembly, clutch cylinder assembly, and brake cylinder assembly (including the little compact booster) it comes to $224. That's pretty darn good for new parts. I think Mahindra makes a pretty decent tractor so I bet the quality is there....

The big question is.... can I get this to work with my existing clutch fork? With the Novak slave kit I've been looking at, I have to drop the tranny in order put Novak clutch fork in there.

 

What motor/trans do you run?

 

225 oddfire v6 and an SM420. I l'd love to not have to drop my tranny. Although if I did it would be hard to resist putting Terra Low gears in my t-case. That would put me around 100:1.

 

I'd like to get some measurements. Thinking about this for a swinging pedal swap in my cj5. What's the distance between pedals? What is the overall width of the mounting bracket? Thanks!

 

Just ordered a set. Now waiting for delivery ( no lead time available from the distributor)
Dennis

 

Cool. Im curious

 

Ended up ordering a set too. Hopefully these work. Was planning on using wilwood swinging pedals but I just can't figure how to get the brake pedal to fit between the steering column and the engine clearance hump on the firewall

 

Where are you purchasing parts from? Do you have a link to the parts view and ordering instructions?

Thanks

RVS

 

Go here: ROXOR Offroad then find the part; if looking for the pedal assembly, it's Item #0802BAA10150N

You will then have to enter your zip code and find the nearest distributor. Call them up and order from them. I spoke with Roxor and they do not sell direct from them.

 

Maybe because I didn't sign in to the Roxor page, but most of the parts I went searching, prices say to "call your dealer". The front fenders are of particular interest. I might stop by the local dealer again to check out the seats in person. They are priced at $68.99 each- a bargain!
-Donny

 

compared to the 300 bucks for smittybuilt, id buy them all day at that price!!

 

Whoever gets one of those pedal assembles first............post some pictures and measurements.

 

Sorry been travelling. You guys still need any pedal assembly measurements?

 

Can you measure
1. Firewall to dash (length of pedal assembly)
2. Total pedal length (pivot to center of foot pad)
3. Pedal pivot to brake pushrod distance ( will give me pedal ratio between 2 & 3)
4. Width of pedal assembly

Greatly appreciate this!
Dennis

 

The above will help me as well though I did go ahead and place an order for these anyway