1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Front U-joint Problem

Discussion in 'Early CJ5 and CJ6 Tech' started by jeff1960cj5, May 31, 2018.

  1. jeff1960cj5

    jeff1960cj5 New Member

    I have a 1960 Willys CJ-5 F-134 and having problems finding the proper u-joint for the front drive shaft. the issue is that the bearing cap in the prop-shaft are .938 and the pinion and output yokes are 1.06 . The local Spicer distributor can't seem to locate anything this size. Has anyone had similar issues or solutions?
     
    jeff1960cj5, May 31, 2018
    #1
  2. PeteL

    PeteL If it wasn't for physics, and law enforcement... 2024 Sponsor 2023 Sponsor 2022 Sponsor

    PeteL, May 31, 2018
    #2
  3. Daryl

    Daryl Sponsor

    Find another driveline if you are asking for a conversion joint at both ends. Both should just be a 1310 joint.
     
    Daryl, May 31, 2018
    #3
  4. Slavcj

    Slavcj New Member

    Had the same problem on my 65 CJ5. I changed both yokes and drive shaft. Cost me about 150 for the used parts.
     
    Slavcj, May 31, 2018
    #4