1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Transfer Case Insulator

Discussion in 'Early CJ5 and CJ6 Tech' started by Steve's 70-5, Jun 17, 2017.

  1. Steve's 70-5

    Steve's 70-5 Active Member

    Got a pictures of a Jeep that I refer to, since I am putting everything back together. I have a T-14,D-18 Trans and T-case There is a insulator on the bar to the cross member. Is the insulator right. I do not have a hole in my cross member for it. I think I used the original cross member I have the bracket and mount that is on the curb side, inside the frame. I searched but could not find a answer.

    [​IMG]Insulator by Stephen K, on Flickr
     
    Steve's 70-5, Jun 17, 2017
    #1
  2. 1967 CJ5A

    1967 CJ5A Mike 2024 Sponsor 2023 Sponsor 2022 Sponsor

    I think that the photo is not of a stock setup. That rubber mount goes between the TC and frame on 4cyl models. My V6 has no hole in that location either, and the TC connects to the frame like you said.
     
    1967 CJ5A, Jun 17, 2017
    #2
  3. Steve's 70-5

    Steve's 70-5 Active Member

    That picture confused me, nothing looked like it was there.

    When you get back from your trip, might want to look at a Wildwood Master Cylinder. Putting one on my jeep and will have the remote reservoirs on the fire wall. Will be nice to check brake fluid levels by just opening the hood.
     
    Steve's 70-5, Jun 18, 2017
    #3