1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Solex Fuel Pressure Specs

Discussion in 'Early CJ5 and CJ6 Tech' started by Leathernek, Mar 22, 2013.

  1. Leathernek

    Leathernek Member

    Ok, i took the carbs apart and they are clean as a whistle on the inside.....so now I assume its the fuel pressure. I know, from a previous post that a Carter runs at about 3psi but what about a Solex. Someone said "alot less than 3psi" but what is it exactly?
     
    Leathernek, Mar 22, 2013
    #1
  2. Strawdawg

    Strawdawg New Member

    Seems like 2 psi is the number. Probably will need a regulator to get that low
     
    Strawdawg, Mar 22, 2013
    #2
  3. Leathernek

    Leathernek Member

    Ok I'll try 2. just got the regulator hooked up, now just gotta put the carb back on.....
     
    Leathernek, Mar 22, 2013
    #3
  4. givemethewillys

    givemethewillys Been here since sparky ran it. 2022 Sponsor

    I thought i remerber someone saying 1.5 psi way back in the day. 2 should be fine however
     
    givemethewillys, Mar 23, 2013
    #4
  5. PeteL

    PeteL If it wasn't for physics, and law enforcement... 2024 Sponsor 2023 Sponsor 2022 Sponsor

    I've heard 1.5 psi also. But I'm wondering why the solex when you have a good Carter?
     
    PeteL, Mar 23, 2013
    #5
  6. WorkInProgress

    WorkInProgress Member

    My jeep came to me with a solex and I could never get it to run just perfect, but then again there wasn't a regulator dropping the pressure down. My opinion; stick with the carter. After rebuilding mine it idles and runs perfect and that's what was designed to be on that motor.
     
    WorkInProgress, Mar 24, 2013
    #6