I recently got my Tranny put back together, with the help of M38Willys (THANKS BRANNON!), and turned it over this morning. I replaced everything,...
I am having a helluva time getting the tranny reinstalled in my '71 CJ5. I replaced the clutch/pressure plate/clutch fork and t/o bearing and...
I got it out with the use of a rented puller from Autozone. It snapped right out. I'm kind of bummed I didn't get to try the grease method, it'd...
OK, Got the flywheel off...you're right it IS heavy!! I managed not to crush anything too important (what's a pinky for anyway) and am wondering...
I got the "shaved down bolts" (due to PO installing a clutch disk backwards) out of the flywheel and am taking it to a shop to be resurfaced. I...
Good points!!! Thanks yet again!
Brannon Thanks again! I was thinking about the flywheel bolts and the flip side of the coin is what if the head is a bit weak and won't withstand...
I can't find the torque for those bolts in my Haynes manual...any idea what it would be?
I was thinking about replacing them as well, might as well since I've got it off. Are they special bolts or can I just grab them at Lowes/Home...
Thanks for the advice, after checking out the fork further one of the "ears" is worn off and there is a groove cut almost through the fork where...
I guess a hammer it will be! I hope the new one goes in easily and doesn't require a beating!!
Here are pics of the T/O bearing. What do I do next?? THANKS
Separate names with a comma.