I just used The cheap half back seats sold on ebay or amazon. I flipped them over and re drilled the underside of the passenger seat frame using...
Keep in mind, If you do go to stock springs you'll need to take out the spacers in the transmission cross member. I think there are 2, sometimes...
The Taper shims realign the pinion angles to the correct angle after lift springs have been installed.
I have torn the Hydro setup I have off and am starting anew. It's really been bothering me that I am so close to getting this thing back on the...
Body swap? Or possibly a early 75 tub titled as a 74?
You'll need to get stock height springs if you want to lower it down. The shackles really aren't that tall and wont do much if you went to stock...
The correct fuel fill and vent hose and hardware is below. It looks like they used the factory fill neck in your current setup You'll need that...
Just browsing some of the pics... I would for sure take a good look at this area behind both front axle spring hangers under your feet. The...
Yes sir!
85w-90 GL1 gear oil. Same stuff I've used since putting the transmission in in 1994.
Yes. Only thing that wasn't replaced was the actual gears. But this wouldn't matter. The rebuild has 700+ miles on it and it's been perfect up...
There's a definitive hard pull to get it out of 3rd gear and down into 4th like somethings jammed up in the works. The synchro have less than...
The back half the roll bar looks to be stock. The front spreader bars above your head and the front hoop have been installed and are definitely...
My t18 is from a later cj with the reverse all the way down and to the right. Ive farted around with the Hydro clutch set Up I put into the...
Separate names with a comma.
