1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Flatfender floor pan panels?

Discussion in 'Flat Fender Tech' started by metal_miner, Jan 3, 2011.

  1. metal_miner

    metal_miner New Member

    Was the M38 the only flatfender to have the large removable floor panels around the transmission hump and firewall?

    -Thanks-
     
    metal_miner, Jan 3, 2011
    #1
  2. m38willys

    m38willys Jeep Vice 2024 Sponsor

    I think so. Don't remember them in any of my 2As but don't know about the War 2 jeeps
     
    m38willys, Jan 3, 2011
    #2
  3. w3srl

    w3srl All-around swell dude Staff Member

    IIRC the MBs were similar to the 2A in that regard.
     
    w3srl, Jan 3, 2011
    #3
  4. garage gnome

    garage gnome ECJ5 welder

    M38's were the only flatties to have the large panel. The M38A1 was based off that, then the CJ5.
     
    garage gnome, Jan 3, 2011
    #4
  5. metal_miner

    metal_miner New Member

    Thanks for your replies.

    The reason I was asking is because my buddy has a M38 with a Chevy 283. Those removable floor panels and flip out dash sure gave a lot of room in which to work... :D ... regardless of engine / drivetrain set-up.
     
    metal_miner, Jan 3, 2011
    #5
  6. 54cj3b

    54cj3b Member

    Wish I had one of those removable center floor sections in my 3b than I wouldn't have had to cut chainsawguy it out to fit this :
    [​IMG]
     
    54cj3b, Jan 4, 2011
    #6