1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Wheel hubs and wheel stud issue

Discussion in 'Flat Fender Tech' started by sammy, Jun 27, 2009.

  1. sammy

    sammy Coca-Cola?

    Using my old Dana 25 as spare hubs for a spare tire carrier for the Jeep and trailer (same hubs)
    I pressed out the old studs and drums, and went to press in just new studs and it seems that they're too small, and wont press in tight enough. Is there a remedy for this?
    Thanks
     
    sammy, Jun 27, 2009
    #1
  2. Patrick

    Patrick Super Moderator Staff Member

    Take the hub with you to your FLAPS and match up some studs.
     
    Patrick, Jun 27, 2009
    #2
  3. sammy

    sammy Coca-Cola?

    they need to be 1/2x20, are there different swage sizes?
     
    sammy, Jun 27, 2009
    #3
  4. Patrick

    Patrick Super Moderator Staff Member

    Yes.
     
    Patrick, Jun 27, 2009
    #4