1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

where would you go to find engine parts for a 225?

Discussion in 'Early CJ5 and CJ6 Tech' started by hansom, Jun 3, 2009.

Page 2 of 2
  1. timgr

    timgr We stand on the shoulders of giants. 2022 Sponsor


    Interesting - is that the final routing for the driver's side, except for the flange location? How will the steering go around the rearmost (#5? Can't remember which side is odd and which is even...) tube?
     
    timgr, Jul 29, 2009
    #21
  2. Warloch

    Warloch Did you say Flattie??? Staff Member

    Odd is the D side - mine looks a little funny due to the 2" body lift I have on it. If you don't have the lift it's pretty clean from the 'normal' column position for doing a Saginaw as the column comes out lower from the firewall.

    For me, I am going to remount the column to position my column end lower - this will actually give me a better setup inside as I am tight on my front cage strecher.
     
    Warloch, Jul 29, 2009
    #22
  3. cj6/442

    cj6/442 Sponsor

    I'll be different again and say I don't like the Headmans 'cause they are inline with the tires. drop off a big rock with the front tire and land smack on the tubes/collector. Hookers are pricey but they exit close to the outside of the frame.just gives you a little bit more ,,,these are the hooker super comps sorry i don't have a pic of my rig displaying the headmans:) .........[​IMG]
     
    Last edited: Jul 29, 2009
    cj6/442, Jul 29, 2009
    #23
  4. Patrick

    Patrick Super Moderator Staff Member

    Does Hooker still make those?
     
    Patrick, Jul 30, 2009
    #24
  5. Simi Valley CJ-5

    Simi Valley CJ-5 Chief Cook and Bottle Washer

    I too am replacing the headers on my 225. I had to return the novak block hugging headers pictured earlier in this thread because the #5 tube interfered with the steering column of my '62 m38a1. I did find what looks like the proper headers at advance adapters (Paso Robles) but have yet to receive them (back ordered). -btw- the headers novak sent me were manufactured by sanders (San Francisco).
     
    Simi Valley CJ-5, Jul 30, 2009
    #25
  6. Warloch

    Warloch Did you say Flattie??? Staff Member

    I currently run the AA Headers - my reason for going to the block hugger design is I want to put sliders on that attach to the outside of the frame. The AA headers with super Traps run right along the frame (hight wise) and that is where I want to attach the slider mounts.
     
    Warloch, Jul 30, 2009
    #26
  7. Tom in RI

    Tom in RI Member

    Tom in RI, Jul 30, 2009
    #27
  8. mike starck

    mike starck Member

    Just wanted to show thw Hedman Headers on my '69.After checking for proper fit and clearance i sent them out to be creamic coated.they did a graet job.

    [​IMG]
    [​IMG]

    ceramic coating : $250.00
    no burnt paint or rust : priceless

    mike s.

    ps: i will be coating the mufflers and tailpipes as well.
     
    mike starck, Jul 30, 2009
    #28
Page 2 of 2