taking apart a door

can anyone tell me how to remove the wing windows,,,or have the diagram,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,thanks...............(if anyone is looking for a drivers door w. little rust let me know)

 

typically, you'll unfasten the regulator arm from the window glass; most likely held by a clip; pry carefully so to reuse the clip; then carefully let the glass settle to the bottom of the door.
Locate the screws that hold the vent assy to the door frame; remove those, tilt and pull the vent window up and out.

 

On the front of the door where the hinges are you'll see two bolts, I think they're 7/16th heads. Remove those. Open the vent window, just back of the pivot on the bottom there should be a small access hole through the seal.There's a phillips or star head screw that attaches the frame to the door. Should pull right up and out after that. No need to remove any regulator bolts.
If you have any problem locating the screw I'll try get a picture tomorrow of where it's located.

 

what year is the Commando in question ?

 

Doesn't matter, they're all the same.

 

Use this link:

http://www.jeepsterpartsdude.com/how_to.htm

Best write-up with pictures you will find on Commando doors.