1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

T14 Rebuild Kit

Discussion in 'Early CJ5 and CJ6 Tech' started by jackdog, Apr 21, 2021.

  1. jackdog

    jackdog Member

    Getting ready to rebuild a T14 for a spare. I always use the Novak kit, but I see they are on indefinite back order. Any other quality kits out there?
     
    jackdog, Apr 21, 2021
    #1
  2. Andrew Theros

    Andrew Theros Member 2023 Sponsor 2022 Sponsor

    Don’t know the answer, but I’m in the same boat so I’ll be watching this thread.
     
    Andrew Theros, Apr 21, 2021
    #2
  3. homersdog

    homersdog Tulsa, Ok 2024 Sponsor 2023 Sponsor 2022 Sponsor

    homersdog, Apr 21, 2021
    #3
  4. timgr

    timgr We stand on the shoulders of giants. 2022 Sponsor

    Regard my post on input bearings - Transmission Front Input Bearings

    A rebuild "kit" should include both main bearings, seals and gaskets, blocking rings, and a "small parts kit" of rollers, bushings, and snap rings.

    Unless there is obvious wear by inspection, you most need to replace the large input bearing and the second gear blocking ring. The 2nd gear downshift is really hard on the 2nd gear blocking ring.

    It is possible to need replacement gears, and replacement synchronizer hubs.

    If your transmission pops out of gear, it may be due to the internal bushing in the gear wearing out. This is common for the T-90, I understand.

    I would put together the parts I needed, rather than a kit.

    These are my opinions - I welcome input based on other's experience.
     
    Last edited: Apr 21, 2021
    timgr, Apr 21, 2021
    #4
  5. Andrew Theros

    Andrew Theros Member 2023 Sponsor 2022 Sponsor

    Informative, thank you. I would guess that you’re referring to my broken second gear?
    As I stated in my post, I planned to rebuild this trans “later”, but I’m glad I found this. I guess later just came along sooner...

    As for the rebuild, I am completely ignorant (if that wasn’t obvious) in the transmission area. If I’m going this far, why not go all the way and learn something while I’m at it. All it is going to cost me is time (and a few extra $$), but hopefully I will earn a little bit of knowledge!

    Regarding speed shifting, you are probably correct. I’ve owned this Jeep since 01 Feb, and she’s been down since mid march. It had 35’s and a whomping stereo/amp/speaker set up in it, so speed shifting wouldn’t surprise me.
    Also lots of little half a$$ stuff I’m finding but that’s for future posts.

    As for Herm, he has the rebuild kits and my second gear, so I reckon I’ll be writing a check and licking a stamp!

    Thanks again for your thoughts!
    Andy
     
    Andrew Theros, Apr 21, 2021
    #5
    homersdog likes this.