-
Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.Dismiss Notice
colojeepguy's Recent Activity
-
colojeepguy liked Jw60's post in the thread Let's Nerd Out On Some Calculations.
If only there was a www.Joetheadapterguy.com
May 2, 2024 at 6:00 PM -
colojeepguy replied to the thread Matkins Ecj5 Frame.
I saw that one recently. My frame has suffered a lot of damage over the years, and I'd like to switch to YJ springs. If I was in better...
May 2, 2024 at 5:31 PM -
colojeepguy replied to the thread 1966 Cj5..
Not all the V6s used a Delco distributor (easily identified by the round rotor and the door in the cap for adjusting pionts) Some used a...
May 2, 2024 at 5:28 PM -
colojeepguy replied to the thread Let's Nerd Out On Some Calculations.
I have, sitting in my shed, a Ford RTS out of a Bronco. Considered going this route in my CJ, but as Fireball posted, the numbers don't...
May 2, 2024 at 5:23 PM -
colojeepguy replied to the thread Let's Nerd Out On Some Calculations.
This. I use the overdrive to split gears a lot, especially off road. With a low HP engine like the Dauntless it really needs more than...
May 2, 2024 at 1:45 PM -
colojeepguy liked FinoCJ's post in the thread Let's Nerd Out On Some Calculations.
I find this an interesting topic.... the vocab of "useless gears" is a bit tricky, whereas overlapping fits better IMO. I see the issue...
May 2, 2024 at 12:26 PM -
colojeepguy liked ITLKSEZ's post in the thread Let's Nerd Out On Some Calculations.
Thanks for doing the math for me! :beer: Not to be the turd in the punch bowl, but 205s and 203s have 1.96:1 ratio, not a true 2:1....
May 2, 2024 at 11:45 AM -
colojeepguy liked wheelie's post in the thread A Couple Special J Trucks.
That's a new one for me too. I thought they had modernized the ALL the beds by this time. I was quite skeptical about this truck until I...
May 2, 2024 at 8:34 AM -
colojeepguy liked Ol Fogie's post in the thread Free Free.
Yeah, or it's a "mad-mad-mad world"
May 1, 2024 at 11:06 PM -
colojeepguy liked FinoCJ's post in the thread For Sale Spring Under High Clearance U Bolt Plates.
Basically I plan to copy their set up which looks like this.... [img] but one of the ends may not be a triangular gusset, but more...
May 1, 2024 at 5:21 PM