On the Kaiser Willy site 646509 looks correct. I know the bracket that fastens to the floor is correct. And the pedal comes off it at an angle,...
Good pics from Jeepster. Mine came with an L shaped metal bracket that is held on by the last bolt that holds the exhaust manifold on. I "assume"...
If your talking about the throttle return spring...I first installed one from the coil bracket to the carb but found at full throttle it over...
Looks good! I might recommend beveling the inside of the tube on each end. They can be pretty sharp after running thru the threading machine.
I have a vacuum advance IAT 4024 distributor on an F134 motor in a 1958 model. Pertronix says they don't offer an ignitor for this distributor....
That's it! It is held by the bolt, that is just above the fuel pump, that holds the timing cover to the engine. The cable goes from the...
Nothing between the rod and underside of the floor. And I am in complete agreement about metal on metal, but this is the way they designed it. I...
Check your thickness. As built the pedal rod is right against the underside of the sheet metal floor. If this moves it down from the floor I don't...
The pieces I used have very little bend to them. You can get 1/8" plywood, 2.7 mm, at any big box store. I wanted plywood as it is more resistant...
If you have even a little skill you can repair broken fender flairs using fiberglass. Out of 2 sets of flairs I was able to get only one of the...
[ATTACH] [ATTACH] Cabinet shop also did the arm rests for me. I got the black plastic push pins off of ebay. $7 for 50 delivered.
I tried to make a headliner using a piece of highly bendable plywood I got at a cabinet shop but just could not get it to fit right so went this...
Separate names with a comma.