Figured I would throw my 2 cents out there even if I am a little late. I have the OTC gauge which does vacuum and fuel pressure. Comes in a nice...
The best resource I have found for overdrive compatibility is Overdrive Tips on CJ3B.info Basically you are looking for the spline and teeth...
I don't have anyway of pulling the bearings off here I would have to drive it over to my dad's shop and pull them there. Also don't have a caliper...
Numbers look to be 1 27 93 picture below. Ring gear looks to be 8-1/2 OD and 5-1/2 ID but it's hard to measure with the ring gear on. Picture...
Thanks for all the info. Looks like I have no use for this power lock do these have any value to them? I would like to sell it so I can grab a...
Here are some photos showing the rest of the stampings. [IMG] [IMG]
Picked up a powr-lok limited slip off a craigslist deal and I assumed it was 19 spline for a later 19 splined dana 44 but after getting home I...
Thanks for all the replies. I didn't drop any tire pressure for that trip because I had no way of bringing them back up to the correct pressure...
After riding for 6 hours on trails in Moab I think it is time for some lighter springs for the CJ-5. I currently have some 5 leaf pack after...
Back after a few years, spent 2 years in Alaska and the Jeep stayed with my dad in his garage. Currently living in Denver with my jeep being a 5...
It's actually really simple and shown in great detail in the FSM. Where most people get confused is they don't have all the parts, most are...
I have the STA Super Traxion in Fig C, great tire good looks, kinda wish I went with NDT's for the looks but the extra traction makes up for it.
Separate names with a comma.