1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Brake Assembly And Booster

Discussion in 'Builds and Fabricators Forum' started by shaun, Feb 16, 2020.

Page 2 of 2
  1. Muzikp

    Muzikp Active Member

    I pulled vacuum for my booster off this large port on the back of my Offy manifold, just behind the carb.

    [​IMG]

    [​IMG]

    You'll need this L shaped fitting not the straight one... ask me how I know :rolleyes:

    [​IMG]
     
    Muzikp, Mar 4, 2020
    #21
  2. shaun

    shaun Member

    Thank you. Vacuum line is attached. Now to work on the assembly this weekend. Hope to get one fabricated.
     
    shaun, Mar 11, 2020
    #22
  3. Lockman

    Lockman OK.....Now I Get It . 2024 Sponsor 2023 Sponsor 2022 Sponsor

    Hey James ........Really Dig those Valve Cover's . Here's Mine :
    Offenhauser Makeover.JPG
     
    Lockman, Mar 12, 2020
    #23
    Muzikp likes this.
  4. BadGoat

    BadGoat How High Can You Climb?

    Do you already have a brake light switch installed? I just went through setting mine up using the early YJ style switch.

    Mike
     
    BadGoat, Mar 12, 2020
    #24
  5. Muzikp

    Muzikp Active Member

    Looks good (y). You have a lot going on in your engine bay, makes mine seem sorta simpleton'ish.
     
    Muzikp, Mar 12, 2020
    #25
    Lockman likes this.
  6. shaun

    shaun Member

    It’s ready to be connected. I’m using a speedway wire harness and checked all wiring just need to be connected.
     
    shaun, Mar 13, 2020
    #26
Page 2 of 2