Vevor Flaring Tool

[Howard Eisenhauer]

Looking for a favor from someone with a Mastercool kit. I'd like the dimensions on the die sets, I'm trying to figure out if the Mastercool 37° dies will fit in the Vevor unit.

Anyone able to help me out?

Someone?

Anyone??

 

[timgr]

Sorry Howard - was not paying attention.
Late. Tomorrow?

 

[Howard Eisenhauer]

Sorry Howard - was not paying attention.
Late. Tomorrow?

That would be fine Tim, Very Much Appreciated!

 

[timgr]

Looks like 1.120" and 1.045".
Let me know if you need more.

 

[Howard Eisenhauer]

Thanks Tim, the Vevors are ~1.5" square so completely different.

 

[Warloch]

When I saw your question I was hoping they would be the same as well. Just in case I have to swap out the pump on my MasterCool setup.

 

[Howard Eisenhauer]

When I saw your question I was hoping they would be the same as well. Just in case I have to swap out the pump on my MasterCool setup.

Ill check mine tomorrow to see what the thread is on the Vevor but it's probably way different from the Mastercool.

Just curious, what do you anticipate going wrong with your pump that a rebuild kit couldn't handle?

 

[Howard Eisenhauer]

Ill check mine tomorrow

44 mm diameter x 2 mm TP .

 

[Warloch]

Ill check mine tomorrow to see what the thread is on the Vevor but it's probably way different from the Mastercool.

Just curious, what do you anticipate going wrong with your pump that a rebuild kit couldn't handle?

Not sure - yet I've not had time to play with it. I was also thinking it would be nice to have the AN on one and Standard on another. When I start plumbing, I seem to be doing more than one thing at a time.

About to start that process with the current build - Brakes and Fuel since they tend to run along the same frame rail.