-
-
Heath_N replied to the thread Affordable Fuel Injection 4.3.How did you come out with this stuff? -
Heath_N replied to the thread Questions on 16” Rims / Tires / Tubes.285, shouldn't have to worry about loosing a bead. Probably be a little tough to dismount though. Nothing wrong with it at low...
-
The 235 85 will fit nicely that’s what I had first.
-
Good point. It's not unmetered air like a mass-air system would be.
-
Heath_N replied to the thread Affordable Fuel Injection 4.3.Hate to ruin the moment but a TBI is speed density, it will just feed fuel to a vacuum leak like that one. Map sensor doesn't know the...
-
I have run 7.50's on 4.5" x16 inch wheels for years, no issues. No tubes. I could air them down to 12 psi on the Rubicon, and never lost...
-
And no, I see no sense covering the plate. There have been at least four breaches of my medical data so EVERYTHING about me is floating...
-
I ran 285/16 on skinny rims for years no tube no safety lip went to as little as 5 psi never lost a bead...your mileage may vary.
-
It's usually what keywords you happened to use. It happens to everyone!
-
...and set your timing indicator since it's adjustable (if it has enough travel). Use something in the spark plug hole to find TDC and...
-
My plan at this point is the following: Double check TDC at #1 and #4 cylinders. Check throttle position sensor is set correctly ( It...
-
Heath_N replied to the thread Affordable Fuel Injection 4.3.No power and running hot indicates late/retarded timing, to me. If your balancer has slipped 8 degrees, I would set it to show 8*...
-
The marks are null and void because the balancer slipped or something. I will recheck TDC in the morning but we found tdc of the piston...
-
Heath_N replied to the thread Affordable Fuel Injection 4.3.Whether the marker is accurate or not, the timing is still later/retarded in the last video compared to the one above it. Was your...
-
Ok videos off the phone from the parking lot, hopefully I can pull the dash camera video soon I don't have a good windshield mount for...
-
-
Loading…
-
Loading…
