707Jeeper
Latest activity Postings About
-
-
Its not a rubicon trip untill someone is still wrenching on their jeep last minute -
I do my best work alone and under pressure….. :shrug:
-
Much stronger. Especially when the wheels are turned to full lock. That's where cross-joints build up a lot of stress and like to...
-
The RCV shafts are 2x stronger than stock shafts even when the wheels are turned to full lock. CV shafts never click and bind up like u...
-
Barley over a week out from the trip and I am finally getting the front axle back in. With new bearings the differential needed re...
-
I worked on loading for the trip. I think it all fits, just need to add 2 big coolers. They can go on top trip morning.
-
Another nostalgia thing. My Dad has a inclinometer in his GPW and I loved to watch it as a kid. I found this on ebay: It's the exact...
-
Jeff stopped over today- things got a little crazy!! This looks like it will be a 6” stretch to the bed. The engine is going to...
-
Finally got around to swapping the valve stems on all the wheels including the spare. The valve stem replacement toolkit makes it a...
-
I just did the same on the DJ. The tool work great. I had no idea they existed until I was searching for a video to swap valve stems...
-
Almost ready for Rubicon trip.
-
This is the only thing I saw that concerned me, front drive shaft is close. I did change out 2* shims for 6* shims. This thing went...
-
Rear locker works.
-
I set my rear bump stops pretty low to keep that big rear end from banging into the rear gas tank. The shocks still have another inch...
-
today I got a couple small things knocked off my list. Decided to bleed brakes again so I could take this for a ride. The SOA in the...
-
-
Loading…
-
Loading…
