-
-
65CJ5 SRD replied to the thread Carter YF 938SD Flooding.Thanks, the manual PDF is especially helpful. -
Once you get a handle on how they operate they're not that bad. I'd recommend Mike's Carburetor Parts for a rebuild kit & instructions...
-
65CJ5 SRD replied to the thread Carter YF 938SD Flooding.Right now the top of the float is sitting level relative to the top surface of the carb. The spec I'm seeing for a resilient needle...
-
65CJ5 SRD replied to the thread Carter YF 938SD Flooding.Yes, I've seen those before and I will look at them again, thanks.
-
65CJ5 SRD replied to the thread Carter YF 938SD Flooding.The throttle shaft was very loose on this one. A machinist friend in minnesota put in some bushings and made a new shaft for me. All...
-
65CJ5 SRD replied to the thread Carter YF 938SD Flooding.OK, thanks. I downloaded the docs, need time to digest them. Rebuild kit was a BWD brand #10096. BIL did the rebuild a few years ago...
-
65CJ5 SRD replied to the thread Saturn Overdrive..Warn OD in mine, no extra gear noise.
-
An overdrive doesn't add any gear noise. It can lower engine rpm and noise which may allow you to hear the already present gear noise...
-
Hi All, Been a while since I posted anything. I still have the Jeep. Been running it again after a long time and had some questions. I...
-
When I made my corner guards, I added a couple heim joints for the tire carrier. There’s a simple latch that ties into the tailgate… and...
-
Sunk float most likely. You could ground the sending unit wire which should make the needle move across the dial. Proves the dash unit...
-
-
Loading…
-
Loading…
