nickmil
In mothballs. From Happy Valley, OR
- Joined
Latest activity Postings Albums About
-
-
nickmil replied to the thread Intermediate Frankenjeep Build.A trick to keep the caliper hose sealing washers from leaking is to anneal them before installation. It softens them up so they seal... -
nickmil replied to the thread Axle relocation question.X3
-
nickmil replied to the thread 1970 Jeep Rebuild.On my rear disc brake setups I use a short soft line to the caliper to make removing the calipers much easier without messing with the...
-
nickmil replied to the thread WATER HEATER PORTS.Usually there is one that comes off the water pump as well.
-
nickmil replied to the thread Repairing cracked fender.Couldn’t hurt. Make sure you use personal protection equipment. It’s not healthy to breathe that stuff as it burns.
-
nickmil replied to the thread Driveline Length.Lloyd Novak (started Novak Adapters) said it best. “Just because you have it doesn’t mean it’s a good swap”
-
nickmil replied to the thread WTB Dana/Spicer 18 main shaft gear nut & washer.Be aware most castle nut styles are a different diameter and thread pitch than the Nylock style.
-
nickmil replied to the thread Selling parts on Ebay.You going to Puyallup this year Daryl? Looks like I will make it but won’t be moving around much.
-
nickmil replied to the thread 1/4" ballbearing in T14a rebuild kit.Probably the kit was also meant for a car application. Probably for the speedo drive gear to locate the gear. I’ve seen it many times on...
-
nickmil replied to the thread Disc brake swap.I’ve seen ‘76 CJ’s optioned with disc brakes. ‘77 became standard.
-
nickmil replied to the thread Putting a T18 behind an AMC engine.Hi Al! If you want to make the T-18 fit a Jeep transfer case I would use the Ford case unmodified on the front. That way it will fit...
-
nickmil replied to the thread Rare holley buick v6.No
-
nickmil replied to the thread Pielut's GM rear disc brake conversion.If you are using a manual master cylinder make sure you use organic pads. Ceramic/semi-metallic pads are designed for power brakes and...
-
nickmil replied to the thread Rare holley buick v6.Great price on the valve covers. I had to pay $200 shipped for the last set I bought. If I didn’t have 2 sets I’d be all over these...
-
-
Loading…
-
Loading…
-
Loading…