-
-
:shrug: I don’t hate it. -
There a few different weld-on shock mounts available....I ended up with these as the short large diameter weldable mount end seemed...
-
I am finally putting to use the high clearance ubolt spring plates that some forum members put together with a group order. Honestly...
-
Barley over a week out from the trip and I am finally getting the front axle back in. With new bearings the differential needed re...
-
I worked on loading for the trip. I think it all fits, just need to add 2 big coolers. They can go on top trip morning.
-
Rich M. replied to the thread Salvage yard dana 30 questions.Don't bother trying to salvage those rotors for reuse. Just get new wheel hubs, rotors, studs.
-
I added a few ‘mods’ to the Jeep: Front recovery hooks A hand throttle Extended differential vents to stay above water Jon B.
-
Rich M. replied to the thread CJ2A Project - WA.You've got 6 in it. If you get 3 you done good. Lots of assembly and kit form there...
-
“Need it gone.” “Lowest I’ll take is $4k.” Pick one. You can’t have both.
-
It really corresponds to the differences in disk thickness. 77/78?is 6 bolt and 1 1/8 thick and 2 bolt is 79 and newer at 7/8 thick. The...
-
Almost ready for Rubicon trip.
-
More posser shots.
-
This weekend was a list of 40 items. Everything from bump stops, to floor mats. I even started gathering gear for the trip. And looking...
-
That beer is well deserved, it looks amazing.
-
Back to the transfer case. This needs to get resolved. So, since I have Tera 3.15 gears, and an overdrive, I do not have an output gear...
-
-
Loading…
-
Loading…
-
Loading…
