Daryl
Latest activity Postings Albums About
-
-
$4650 seems pretty close to free. -
I just had a conversation with Tom Woods about a new CV style rear drive shaft for my JEEP, and was told that the components measured...
-
Daryl replied to the thread WTB Dana/Spicer 18 main shaft gear nut & washer.Send me an address.
-
Daryl replied to the thread WTB Dana/Spicer 18 main shaft gear nut & washer.
-
-
Daryl replied to the thread Fc With Duals And A Dana 70 Rear?.Seals and bearings should be simply matching what you have. Unless rusted and pitted, the bearings you have are probably better than...
-
2 extra zeros
-
Daryl replied to the thread 304 Block Crack.It just took me 3 months to give away a good running 258. I have never once had a customer ask for a 304 motor. I guess location is...
-
AGREE If I had it to do over again, I would not even consider an AMC engine.
-
Daryl replied to the thread Selling parts on Ebay.I have a 67 windshield with the original motors.
-
Received my parts yesterday, thanks Daryl.
-
Daryl replied to the thread Selling parts on Ebay.300 orders shipped or picked up so far. 43 distributors sold.
-
Good for us. If I was closer I'd show up with cash and a trailer and start at 4500. I'll bet he would take 4800 which almost makes me...
-
Daryl replied to the thread 46 Flat Fender - TX.Monroe lift arm mounts on the drawbar. The absolutely unobtainable Monroe center mount above the rear gearbox also!.
-
Daryl replied to the thread SPEEDO CLUSTER WIRING.1. 12 volt power 2. Do not touch. 3. Sender 11. Sender 12. DO NOT TOUCH!. As mentioned above, do not allow power to be turned on...
-
-
Loading…
-
Loading…
-
Loading…
