-
-
wheelie replied to the thread WTB still looking for 4.88 speedo gears.The pieces I would prefer are: 447331 and matching 448494 or 447537 and matching 448858 -
wheelie replied to the thread WTB Two hole knuckle.Geez. I sell stuff way too cheap I guess. Stuck in the 90s I suppose.
-
wheelie replied to the thread WTB still looking for 4.88 speedo gears.Kaiserjeeps.....I'm a bit befuddled with the application for the 448110 gear as it's shown on the list above. Shown as used with both...
-
wheelie reacted to Howard Eisenhauer's post in the thread What Did You Do To Your Jeep Today? with
Like.
Check those brakes on a nice empty piece of road before you go too far- without a proportioning valve you may find yourself facing the... -
Doubt it but at least he'll be a little further back so I won't hear the screaming coming down Red Cone
-
That was me :D
-
wheelie replied to the thread What Did You Do To Your Jeep Today?.Put a new master cylinder on the 71 along either new lines from there to the distribution block. I installed them in reverse when I...
-
I used to have a chimney brush (about 4’ long) where I clipped the metal bristles shorter. I probably still have that up at Hatteras...
-
Also note that the rear plates for 70-75' Flanged axles are different than the earlier tapered axles ones. The flanged axles have a...
-
wheelie replied to the thread 225 and automatic.I’ll need to source that transmission for when my kid receives the keys to the 71. Her ability the learn to drive a clutch has been no...
-
wheelie replied to the thread WTB still looking for 4.88 speedo gears.The speedo in the 71 is way off. I’m running 4.88 gears with 33 inch tires and the 3.73 speed gears. I’m off about 10 mph at road...
-
wheelie replied to the thread WTB Glove Box Door Button / Latch.I think I can help. I’ll look in the shelf tonight.
-
wheelie replied to the thread WTB still looking for 4.88 speedo gears.I have the numbers but thanks all for posting. None of the sets I have are correct.
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…