V6 Water Pump Cap?

Got my Heater Delete panel installed, yea!! But, would have been used to plug the nipple on the water pump that goes to the heater? This is on a '67 CJ6 - 225 V6 - Stock engine.

 

Likely a cap. Dorman sells a cap for this purpose, 02250 5/8" and 02251 3/4". www.dormanproducts.com Any parts store can get Dorman stuff.

 

I usually just loop a hose back to the other nipple on the intake.

 

That is how I have been running it. Just was wondering how the factory would have configured it.

Was there a different Water Pump? So far haven't found anything in the parts book about heater delete.

Off to FLAPS to get a Dorman cap.

 

There would have been a rubber cap with hose clamp over the nipple I believe.

EDIT. This is what the parts manual shows.

 

Thanks. Where is this in the parts manual did you find this. I have searched and searched and couldn't find it. Probably in an obvious place, but I cant see it.

Jon.

 

Group 2 Cooling
shown with the water pump
Page GR2 - L2 in my parts book.
I couldn't get my printer to scan the page last night,
otherwise I would have posted it.

 

OK, thanks. Must have a different parts book than mine. Mine is a Kaiser publication Copyright 1967. Cooling group is Group 10, and the page numbers are different.

Thanks

Jon.

 

It's called a cap in the parts manual p/n 930864 if you want to look for the p/n.
It's just a rubber slip on cap with a hose clamp.

 

fwiw the water pump that came off of the marine 225 we just used didnt have the hose fitting on it, and it was cast iron not aluminum.

 

1955 WILLYS JEEP CJ5 BARN FIND
I believe this jeep to be completely stock, do the engine compartment pics help any?

 

Not really, I have a V6 this one is a 4 banger.

But thanks for posting, may help someone else.

 

My bad, didn't realize you had the V6

 

Here's a scan of the parts manual page that shows the cap for the V6 water pump.