1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

T90 Transmission Question?

Discussion in 'Early CJ5 and CJ6 Tech' started by 1957Willys, Feb 5, 2018.

Page 2 of 2
  1. Jun 5, 2018
    Glenn

    Glenn Kinda grumpy old man Staff Member

    Apopka, Fl
    Joined:
    Sep 21, 2002
    Messages:
    12,375
    It's just straight up, extended with a pipe through the removable cover. You could reuse the cap if you want. I just have a fitting on top and a short piece of brake/gas line tubing bent to point somewhat down for a vent. Just drill a hole in the cover and use a rubber grommet big enough to allow for some flex.
     
    Glenn, Jun 5, 2018
    #21
  2. Jun 5, 2018
    Keys5a

    Keys5a Sponsor

    Florida Keys
    Joined:
    Jan 23, 2014
    Messages:
    4,188
    Taking a note from the Land Rovers I play with, they have a great venting system. They just use a hose barb type fitting that threads into the case (transmission, transfer case, axle housing, etc) and molded piece of polyethylene tubing that snakes up to a high point, usually engine bay. The tubing has a molded-in 180 degree "hook" on the end so water won't get in. The tubing just snips with a digonal cutter and a twisted piec of tie wire secures them to the barb fitting.
    I collect these out of the U-Pull yards as they can be adapted easily to anything, including our Jeeps. They usually charge me about $4, except the time I got 7 vent tubes on one visit. They were $8 for all of them.
    -Donny
     
    Keys5a, Jun 5, 2018
    #22
    Glenn likes this.
  3. Jun 5, 2018
    william_cj3b

    william_cj3b 3BOB driver

    Milton, FL
    Joined:
    Nov 17, 2003
    Messages:
    421
    I think there must be an interdimentional wormhole between my transfer case and yours...:worry:
     
    william_cj3b, Jun 5, 2018
    #23
    Glenn likes this.
Page 2 of 2
New Posts