1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

T90 Shift Rail End Caps

Discussion in 'Flat Fender Tech' started by DanStew, Apr 23, 2017.

  1. Apr 23, 2017
    DanStew

    DanStew Incorrigible. Staff Member Sponsor

    Lexington, South...
    Joined:
    Sep 22, 2002
    Messages:
    4,093
    Are there two different sizes on the Shifter?

    I ordered two of them a while ago and when i went to install them they were too large for the bore. These are for the rear shifter rails. I tried to kind of seal it by putting a piece of sheetmetal behind the bores and seal it, but today when i was shifting my little fix popped out with teh quickness. So i need to find a smaller end cap to keep the oil in the tranny.
     
  2. Apr 23, 2017
    Howard Eisenhauer

    Howard Eisenhauer Super Moderator Staff Member Sponsor

    Tantallon, Nova...
    Joined:
    Nov 22, 2003
    Messages:
    4,928
    I installed caps on a tranny that had not been made for them- I had to bore out the ends of the rail holes to 5/8" for them to fit. I also filed some groves in the bores to relieve pressure when the rails move backward.

    [​IMG]

    [​IMG]

    [​IMG]

    H.
     
    Focker and Glenn like this.
  3. Apr 24, 2017
    Keys5a

    Keys5a Sponsor Sponsor

    Joined:
    Jan 23, 2014
    Messages:
    1,391
    Nice touch Howard! I wouldn't have thought to cut the relief grooves to keep from hydraulicing the rail.
    -Donny
     

Share This Page

New Posts