1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Really stupid Pilot bushing question

Discussion in 'Early CJ5 and CJ6 Tech' started by DanStew, Jun 29, 2004.

  1. Jun 29, 2004
    DanStew

    DanStew Preowned Merkin salesman Staff Member

    Lexington, South...
    Joined:
    Sep 22, 2002
    Messages:
    4,585
    Well the grease worked!!! I got the bushing out. but now my question... The bushing has a flat side and a side that has a machined angle to it. the angle goes into the center of the bushing. Not a large angle mind you. But which side goes in the crank?? Flat side or angled side??

    Thanks!!!!
     
    DanStew, Jun 29, 2004
    #1
  2. Jun 29, 2004
    Mcruff

    Mcruff Earlycj5 Machinist

    Albertville, AL
    Joined:
    Sep 22, 2002
    Messages:
    5,349
    If the angle is to the pilot hole this is the side that is suppose to be visible when the pilot bushing is installed, it acts as a pilot for the tip of the transmission and a break for the corner of the transmission shaft to keep stress off the fillet between the tip and the shaft body where the splines are.
     
    Mcruff, Jun 29, 2004
    #2
  3. Jun 29, 2004
    DanStew

    DanStew Preowned Merkin salesman Staff Member

    Lexington, South...
    Joined:
    Sep 22, 2002
    Messages:
    4,585
    Thanks Mike!!!I kind of thoguht that, but then i also thought maybe it went into the bore so that removal would be easier.
     
    DanStew, Jun 29, 2004
    #3
New Posts