1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Np435 Four Speed

Discussion in 'Builds and Fabricators Forum' started by sterlclan, Mar 5, 2018.

  1. Apr 1, 2018
    sterlclan

    sterlclan Member 2022 Sponsor

    exploring the...
    Joined:
    Feb 21, 2009
    Messages:
    3,886
    [​IMG]

    1/2 inch lexan pto view port,makes checking oil and condition of said oil easy.
    [​IMG]
    just misses the pass side exhaust there is like 3/8 inch it just looks like less,may do some heat wrap here.
     
    Last edited by a moderator: Apr 2, 2018
    73 cj5, 47v6, ITLKSEZ and 1 other person like this.
  2. Apr 3, 2018
    sterlclan

    sterlclan Member 2022 Sponsor

    exploring the...
    Joined:
    Feb 21, 2009
    Messages:
    3,886
    its hanging on its own mount instead of the jack. went a few rounds with the clutch release fork,it just contacted the back of the three finger pressure plate when it was released. heated and beat a slight relief in the fork,through the window around the exhaust. it is not hitting now. i wish i had noticed this before it was all in.
     
  3. Apr 4, 2018
    sterlclan

    sterlclan Member 2022 Sponsor

    exploring the...
    Joined:
    Feb 21, 2009
    Messages:
    3,886
    [​IMG]
    Started the new tunnel
    [​IMG]
     
    Last edited: Apr 4, 2018
  4. Apr 5, 2018
    sterlclan

    sterlclan Member 2022 Sponsor

    exploring the...
    Joined:
    Feb 21, 2009
    Messages:
    3,886
    going to take a test drive after supper still need to get a front driveshaft,will be going to the boneyard Saturday and grab one off of a Cherokee and shorten it up.
     
    47v6 likes this.
  5. Apr 6, 2018
    sterlclan

    sterlclan Member 2022 Sponsor

    exploring the...
    Joined:
    Feb 21, 2009
    Messages:
    3,886
    Put thirty miles on today back to daily driver duties. Everything looks and feels good.:D
     
  6. Apr 9, 2018
    sterlclan

    sterlclan Member 2022 Sponsor

    exploring the...
    Joined:
    Feb 21, 2009
    Messages:
    3,886
    Shaft all done, waiting on mud season to end so I can try the granny gears out. Can’t believe how quiet this one is compared to the hagging t 14.
     
    Bowbender and ITLKSEZ like this.
New Posts