front and rear wheel seals.

Here are some picture of one that my dad had in his pile of parts.


From left to right outer hub assembly, then snap ring on end of drive axle, the drive hub with like 8 1/4" X 3/4" bearings and the the outer spindle nut. It should 4-6 notches in the outer rim (the one I took out had none) and 3 small set screws ( you can see these in the parts brake down(upper left Part # SE205)


Hub removed and outer nut removed. You can see the washer with small hole in it remove this next it has a tang on the inner side, and the remove the inner nut. Thi should let you get to the bearing to repack them.

Andrew

 

One like this, do not know if this is the one you need.But it give you a idea what it look like.
Spindle Nut Socket Wrench, This Spindle Nut Socket Wrench is Necessary for 4WD Wheel End Disassembly in Order to Repack Bearings, Replace Seals, Universal Joints or General Wheel End Service.
2 Images
<< Prev Next >>


Bottom
Part: NCP 2782023
Product Line: NAPA Chassis Parts

Price
Unit
:
:
29.59
Each


Qty


Features & Benefits
Manufactured Using Hardened Steel for Durability.
Attributes
Product Application : This Spindle Nut Socket Wrench is Necessary for 4WD Wheel End Disassembly in Order to Repack Bearings, Replace Seals, Universal Joints or General Wheel End Service.

Warranty
Limited Lifetime-See Manufacturers Written Policy

Warranty PDF

Material Safety Data Sheet (MSDS)
There is no MSDS for this item

 

ok
my neighbor has one of those.

 

There is a thin, flat washer that you are supposed to bend over the flat of the nut to hold it in place. If the lock washer is bent over the nut, the socket will not go onto the nut.

 

On this type of nut the little set screws hold the outer nut from turning, this set is different than most CJ JEEP.
Tim, The are like the nuts on your J10 truck
Andrew

 

i need to open it up again
and flush it out with brake cleaner so i can see what exactly is going on in there.

 

too late.
i was confused the day i bought this thing!R)

 

ok this is what i got.

 

i dont like the looks of that stripped,chewed up part.
i dont have anymore money.
it looks like once i get the stripped part off the socket will fit.

p.s.
i looked again.
i think the stripped area is part of the giant nut.

 

Don't look good, If you can get in try a pare of Channel lock pliers
Might have a set of used hubs.
Andrew

 

Channel lock pliers wont fit.

this really stinks........

AY YAI YAI
what have i gotten myself into?:?

 

are those the outer wheel bearings we are looking at in these photos?

 

..

 

i have got half a mind to get some kind of syringe.
squirt grease between those bearings.
and forget i ever opened up those hubs....