1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

F-134 Is There An Explanation For Mmo Leaving Cylinders Into Coolant?

Discussion in 'Early CJ5 and CJ6 Tech' started by Tank Slapper, Sep 6, 2018.

  1. Sep 6, 2018
    Tank Slapper

    Tank Slapper New Member

    Western Wa.
    Joined:
    Sep 6, 2018
    Messages:
    3
    Hi, My jeep has sat for 5 years now so as a tradition I poured Marvelous Mystery Oil into each cylinder through the spark plug hole. 3 months ago I added a quart or two and last week I poured two quarts into the jugs over time. I went to drain the cooling system and to my amazement it was all red MMO and Water mix. Is there an explanation for this other then a blown head gasket, cracked hear or block? I have the exhaust manifold off as I was going to do a valve adjustment and get her singing like a song again.
     
  2. Sep 6, 2018
    Twin2

    Twin2 not him 2024 Sponsor 2023 Sponsor 2022 Sponsor

    Virginia Beach, VA
    Joined:
    Apr 28, 2011
    Messages:
    5,420
    if the engine will turn over with starter
    a compression test would be where I would start

    oil and water don't mix . so that's not a good sign
     
  3. Sep 6, 2018
    PeteL

    PeteL If it wasn't for physics, and law enforcement... 2024 Sponsor 2023 Sponsor 2022 Sponsor

    Hills of NH
    Joined:
    Aug 3, 2003
    Messages:
    9,816
    Not that I can think of.

    I would have used a few spoonfuls, rather than quarts... :shock: I would expect to see the MMO in your crankcase, not the cooling system
     
  4. Sep 6, 2018
    47v6

    47v6 junk wrecker! 2023 Sponsor 2022 Sponsor

    USA
    Joined:
    Oct 25, 2006
    Messages:
    5,801
    Bad head gasket or cracked head ?
     
  5. Sep 6, 2018
    Tank Slapper

    Tank Slapper New Member

    Western Wa.
    Joined:
    Sep 6, 2018
    Messages:
    3
    Ran a compression test no. 2 and 4 were both low at 60 psi. Adjusted the valves with no improvement. While I had the manifold off I notice exhaust valve no.4 has a guide broken almost clean in half vertically, wonder how long it's been like that. Next step pull the head, hopefully no cracks I'm not against rebuilding a f- head.
     
New Posts