dana 27 yoke

Is there a large u joint yoke made tht fits the dana 27 dif.??? ihave searched the forum but found little info.

 

Yes there is. Used on Early Wagons and Pickups with the 27 front and also IH Scouts with the 27 front. I "may" have one, I'd have to check. I'd put a WTB ad in the classifieds. I'll check and see if I have one when I get the chance. May be later today though. I think R&P has some used ones on the shelf as well. 503-577-8160 9-5 PST, Mon-Fri

 

Thats great thanks, my drive shaft is shot but had two shafts for the large ujoints and a yoke for my transfer case. So i just finished cutting one up to make a drive shaft that has a large u joint on one end and the small u joint on the other. I am still looking though so all my ujoints are the same. That small joint looks kinda weak to me.

 

I had a driveline shop cut down a large one for me. As I recall the only differnece was the length of the new one. I'll see if I have a P/N somewhere.

 

So I found some part numbers for the yokes but not sure who the manufacturer is
2-4-8091X End Yoke
2-4-6011X End Yoke
2-2-329 Flange Yoke Parts
This allows me to run 13130 ujoints on both drivelines.

 

thanks I appreciate your help

 

You could use a U-Joint with two different cup and cross sizes, one for the small yoke on the diff and one for the large yoke on the shaft. Most driveline shops should have them.

 

Try Herm.
Herm the overdrive guy that is.

 

I wil try Herm also, seems like an upgrade every one would want on their 27 diff. I havent broke one of the small ujoint yet but they sure look weak to me. I'm running 33" super swampers with the front end locked, so far I havent had to get into it to get thru anything but theres always the first time.

 

Oh the numbers jzebers posted seem to be Spicer numbers to build the drive shaft. What I need is a yoke for the Dana 27 front differential that fits the large ujoints. Good info though and I'll keep it cause I may need to build one.

 

I looked finally and must have sold the ones I had. Either put an ad in the classifieds or Call R&P. I know they had a couple of large u-joint 27 yokes on the shelf a couple of weeks ago. Paul's eyes sometimes aren't so good so make sure you have him double check the seal surface for pits or grooves. A small groove is ok but pits are bad. Nickmil

 

Thanks for looking, I will call tomorrow

 

I spoke to Paul last night and he said he will be gone from today (Friday) until Tuesday so if you don't get an answer on the phone that's why. I guess even old farts need a vacation once in a whileR). Tom may be there covering the shop.

 

I can't say thanks enough for you taking time to help me out. I will call him next week, I'm kinda busy too this weekend, first day of bow season Monday so I'll be in the mountains givin em what fer. Tomorrow is our redneck vacation ( payday at Walmart) Sunday put brakeshoes on the Chevy Put all new hoses on the jeep adjust the brakes, get the archery gear ready.anyway thanks again