ARB airlocker wiring diagram?

I have been looking at my wiring and something doesnt look right when it comes to the ARB harness where it connects to the existing wiring... does anyone have the paperwork that shows the wiring diagram that they could scan and post? This is one of the older pumps, not the same one they have now...

 

The few I've seen were all diff.
Whats wrong?

 

I think I may have figured it out.. but I'll double check... I may go out there with a battery and a jumperwire and see what it does... Right now I have one red wire coming out of the loom out near where the relay is (with a inline fuse). This is the only wire I can see for power.. is that supposed to go to the switch that turns the compressor on?

ps- this pump was manu'ed in July 94...

 

Thinking hard here. Should be just the one. Seems we only found one fuse on the last one I worked on. Took over an hour to find the thing. Blown fuse and all.
Is it working?

 

I figured it out.. I took the wiring harness and unwrapped it. I had already modified it a lot by getting rid of the 2 push switches and replacing them with one lightswitch. (One notch out locks the rear and two notches out locks both, works pretty slick.) There is a red wire that runs to the pressure switch then to the relay to turn the compressor on, I had that wire going the wrong place, now it all works and is wired in. I have learned a LOT about wiring a CJ in the last few days, Makes me wonder why anyone would get a wiring harness, they are so simple, well I should say my CJ is simple now that I've run new wiring. I'll be posting pictures of the progress later today on my gallery.

 

Glad you got it fixed.