How to boot the twin stick and the over-drive coming through the floor of an M-38?

How are you guys booting your twin sticks coming through the floor? I've got an aftermarket boot with the hold down ring, but its not gonna work (or its not gonna look right rather) because I've got my over-drive lever coming up through the tranny cover and thus had to cut the tranny cover to make a hole for the over-drive lever. What I now have is one oblong hole extending from the right side of the tranny cover (left to right) into the hole for the twin sticks. Does any one make a three-stick boot of some sort that looks half decent?

Thanks

Jordan

[/URL][/IMG]

 

Re: How to boot the twin stick and the over-drive coming through the floor of an M-38

http://www.ebay.com/itm/Triple-stic...Parts_Accessories&hash=item3cb2369a68&vxp=mtr

 

Check out JB Fabrication here in Oregon also. They build the shifter conversions for a bunch of transfercases and have a triple boot.


Sent from my iPhone using Tapatalk

 

Re: How to boot the twin stick and the over-drive coming through the floor of an M-38

Or here:http://www.hermtheoverdriveguy.com/id21.htm
About halfway down the page.

 

Re: How to boot the twin stick and the over-drive coming through the floor of an M-38

http://www.hermtheoverdriveguy.com/id42.htm

This works good, I used it on two of mine. basically a retaining ring, and a flat piece of rubber that covers the hole cut into the side of your stock shift cover. ring bends to fit the hole.